vi
Do not touch air outlet grille and bottom plate which becomes hot.
•
Clean the air filter frequently if have. The temperature inside may rise and
•
cause damage when the filter/ventilation slots clogged with dirt or dust.
•
Do not look into the air outlet grille when projector is operating. It may
hurt your eyes.
Always open the lens shutter or remove the lens cap when the projector is
•
on.
•
Do not block the projector lens with any object when the projector is
under operation as this could cause the object to become heated and
deformed or even cause a fire. To temporarily turn off the lamp, press
HIDE on the remote control.
The lamp becomes extremely hot during operation. Allow the projector to
•
cool for approximately 45 minutes prior to removing the lamp assembly for
replacement.
Do not operate lamps beyond the rated lamp life. It could cause it to break
•
on rare occasions.
Never replace the lamp assembly or any electronic components unless the
•
projector is unplugged.
The product will detect the life of the lamp itself. Please be sure to change
•
the lamp when is showing warning message.
When changing the lamp, please allow unit to cool down, and follow all
•
changing instructions.
Reset the "Lamp Hour Reset" function from the Onscreen display
•
"Management" menu after replacing the lamp module.
Do not attempt to disassemble this projector. There are dangerous high
•
voltages inside which may hurt you. The only user serviceable part is the
lamp which has its own removable cover. Refer servicing only to suitable
qualified professional service personnel.
•
Do not stand the projector on end vertically. It may cause the projector to
fall over, causing injury or damage.
This product is capable of displaying inverted images for ceiling mount
•
installation. Only use acer ceiling mount kit for mounting the projector
and ensure it is securely installed.
The projector should be placed in a horizontal way by means of desktop or
•
ceiling mount mode only, and its tilt angles should not exceed 6 degrees,
otherwise it would cause dramatical decrease of lamp life or severe safety
concern of system malfunction.
6°
6°