Table of Contents
Advertisement
Troubleshooting
Problem
Vibrates excessively or
makes noise.
Stops.
The TUB CLEAN alarm does
not turn off.
40
English
Untitled-5 40
• Make sure the washing machine is set on a level floor. If the floor is
not level, use the levelling feet to adjust the washing machine.
• Make sure the washing machine is not contacting any other object.
• Make sure the laundry load is balanced.
• Make sure the laundry is spread evenly in the washing machine.
Spread out the laundry evenly and start again.
• Make sure the space around the washing machine is free of objects.
• Humming is produced normally during operation.
• Objects such as coins can cause noise. Remove these objects from
the washing machine after washing is complete.
• Plug the power cord into a live electrical outlet.
• Check the fuse or reset the circuit breaker.
• Close the lid, and press Start/Pause (or press and hold Start/Pause
for 3 seconds) to start the washing machine. For your safety, the
washing machine will not spin unless the lid is closed. (This only
applies to the models with the lid-locking feature.)
• Before the washing machine starts to fill, it will make a series of
clicking noises to check the lid's lock and does a quick drain.
• There may be a pause or soak period in the cycle. Wait briefly and the
washing machine may start.
• Make sure the inlet hose screens at the taps are not clogged.
Periodically clean the screens.
• This problem occurs temporarily due to low voltages, and will be
solved when power recovers.
• When the machine is diagnosed to be cleaned, the TUB CLEAN
indicator blinks for an hour. This recurs 6 consecutive times until you
run the TUB CLEAN cycle. This is normal, and not a system failure. To
keep the tub clean, it is recommended to run the cycle once every 1-3
months.
Action
2023-05-16( )
6:06:25
Advertisement
Table of Contents
