Page 1
BUILT-IN ELECTRIC HOB INSTALLATION AND USER INSTRUCTIONS MA X MA X MA X MA X KNC-PF302SX KNC-PS604SX Note: Do not use the hob until you have read the instruction manual...
Page 2
OPERATING INDICATOR OPERATING INDICATOR (1000W/6") (1600W/7") KNC-PF302SX KNC-PS604SX Even if you have used a electric hob before, it is important that you read these instructions thoroughly before starting to cook, paying particular attention to the installation and safety instructions. If you have any problems with installing, operating, or cooking with your hob, please check through these instructions thoroughly to make sure that you have not missed anything.
Page 3
DISPOSAL Waste electrical products must not be disposed of with household waste. This equipment must be returned to the retail store for safe disposal. DISPOSAL: Do not dispose this product as unsorted municipal waste. Collection of such waste separately for special treatment is necessary. IMPORTANT SAFETY INSTRUCTIONS Read the manual carefully before use.
Page 4
HOW TO USE Place the appliance on a flat, dry and heat-resistant surface. Turn the temperature knob to “off” position. Put the plug into the power supply. Switch on the temperature knob to the desired setting. The appliance cycle on and off to maintain the setting temperature.
INSTALLATION INSTRUCTIONS BEFORE USING YOUR APPLIANCE Remove the exterior packing. Check if there is any damage to the unit. Clean the unit. A thorough cleaning with a recommended cooktop cleaner will provide a clean, shiny coating on the cooktop surface. INSTALLATION OF YOUR APPLIANCE Follow these directions to prepare the countertop cutout and install your cooktop: 1.Countertop Preparation...
Page 8
Installing the Cooktop There are four mounting brackets supplied with the electric cooktop. These brackets are designed to hold the cooktop firmly in place. The cooktop should be bedded to the countertop using a soft bedding compound that will prevent damage if later removal for service is necessary.
ELECTRICAL CONNECTION WARNING Improper connection of the equipment-grounding can result in the risk of electrical shock. If the power cord of the unit is damaged, have it replaced by an authorized service center. The appliance must be properly installed and grounded by a qualified technician in accordance with the National Electrical Code ANSI/NFPA No.
2.4-Wire Power Cord Installation IMPORTANT: Use the 4-wire cable from power supply where local codes do not permit connecting the frame-ground conductor to the neutral (white) junction box wire. 1. Disconnect power 2. Remove junction box cover if present. 3. Connect the flexible cable conduit (3) from the cooktop to the junction box (4) using a UL listed or CSA approved conduit connector (7).
Using a lid while cooking will minimize the loss of heat and decrease the cooking time. Copper-bottom and aluminum pans may leave a residue on the cooktop in the form of metallic lines. This is normal. These lines can be removed using a non-abrasive ceramic cooktop cleaner or a shielded scraper blade.