Related Manuals for Karinear KNC-D22082-UL
Summary of Contents for Karinear KNC-D22082-UL
- Page 1 Karinear Instruction Manual/ Installation Manual Electronic knob Control Ceramic Hob MODEL: KNC-D22082-UL...
-
Page 2: Installation
Safety Warnings 巳 Your safety is important to us. P|ease read this information before using your cooktop. Installation Electrical Shock Hazard 丘 | Disconnect the app|iance from the mains e|ectricity supp|y before carrying out any work or maintenance on it. 巨... -
Page 6: Product Overview
． |卒 三气：三 三｝：三 三产 二 己 steam cleaner is not to be used. 已 'The appliance is not intended tobe operatedby means ofan exter nal timer or separate remote-control system. Congratulations 回 °n the purchase of your new lnduction Hob. We recommend that you spend some time to read this Instruction/ Installation Manual in order to fully under... -
Page 7: Product Information
Control Panel 1.Power regulating controls 2.Heating zone selection controls 3.OFF/ON control Product Information The microcomputer ceramic cooker hob can meet different kinds of cuisine demands because of resistance wire heating, micro-computerized control and multi-power selection, really the optimal choice for modern families. The ceramic cooker hob centers on customers and adopts personalized design. -
Page 8: Using Your Ceramic Hob
Make sure that the base of your pan is smooth, sits flat against the glass, and is the same size as the cooking zone. Always centre your pan on the cooking zone. 亡 Always lift pans off the ceramic hob - do not slide, or they may scratch the glass. -
Page 14: Technical Specification
(layers of different metals vibrating differently). Technical Specification Cooking Hob KNC-D22082-UL Cooking Zones 2 Zones Supply Voltage 220-240V~, 50-60Hz Product S ize LxWxH(mm) Installed Electric Power 2000W... -
Page 18: Power Line
Power line 1. If the cable is damaged or needs replacing, this should be done by an after-sales technician using the proper tools, so as to avoid any accidents. 2. If the appliance is being connected directly to the mains supply, an omnipolar circuit breaker must be installed with a minimum gap of 3mm between the contacts.