Page 1
WITH SMALL PET DOOR • READ ALL INSTRUCTIONS BEFORE ASSEMBLY AND USE OF PRODUCT. • KEEP INSTRUCTIONS FOR FUTURE USE. www.carlsonpetproducts.com Carlson Pet Products, Inc. 3200 Corporate Center Drive, Suite 105 | Burnsville, MN 55306, USA 952.435.1084 Made in China...
Before Using Product Read and follow all instructions carefully to ensure that your pet pen and canopy are properly assembled. The safety of your pet is your responsibility. Please keep these instructions for your reference. WARNING • KEEP INSTRUCTIONS FOR FUTURE USE. •...
Before Assembly PLEASE CHECK TO MAKE SURE YOU HAVE THE FOLLOWING PARTS: Pet Pen Canopy Buckle Strap ENGLISH...
Page 5
Setting Up Your Pet Pen STEP 1 Expand pet pen. STEP 2 Step down on the locking bar to complete set up. NOTE: First time assembly you may need to adjust strap tension by tightening or loosening buckles on the bottom hinges. ENGLISH...
Page 6
Setting Up Your Canopy STEP 1 Pull the cord at the top straight up and away from the canopy until you hear a click. This action will engage the top button to lock the canopy in place. NOTE: Ensure your canopy is secure and the button at the top of the canopy has engaged, before attaching the canopy to your pet pen.
Page 7
Attaching Your Canopy To Your Pet Pen STEP 1 Line up the corners of the assembled canopy with the corners of the assembled pet pen and place the canopy on top of the pet pen. STEP 2 At one corner of the canopy, pull the elastic cords behind the hinge of the pet pen. Fasten the elastic cords together at the base of the hinge.
Page 8
Detaching Your Canopy From Your Pet Pen STEP 1 At one corner of the canopy, unfasten the elastic cords. Repeat step for remaining five corners. STEP 2 Push the button at the top to collapse your canopy. Fold and put away. ENGLISH...
Page 9
Folding Your Pet Pen STEP 1 Lift up on locking bar to release frame tension. STEP 2 Pull hinges towards center of pet pen to collapse the frame. ENGLISH...
Page 10
STEP 3 Wrap buckle strap around center of play yard and tighten to secure.
Page 11
Removing Mesh Insert NOTE: It is easiest to remove the mesh insert when pet pen is not fully expanded. STEP 1 De-thread strap from buckle and base hinge until strap is free. Repeat for remaining hinges. STEP 2 Reach under top hinge flap to disconnect snaps.
Page 12
Reattaching Mesh Insert NOTE: It is easiest to reattach the mesh insert when pet pen is not fully expanded. Ensure the pet door is not aligned with the locking bar when reattaching. STEP 1 Wrap hinge cover flap over then under the hinge and snap to inner side of the hinge. Repeat for remaining hinges. ENGLISH...
Page 13
STEP 2 Thread end of strap through the slot on the bottom of the hinge up towards the buckle. Make sure strap is not twisted. ENGLISH...
Page 14
STEP 3 Attach strap to buckle as shown in image below. Repeat Steps 2-3 for remaining buckles until the pet pen is fully fastened. NOTE: Do not tighten straps until all straps are attached to each corner and the pet pen is fully expanded.
Page 15
CARE AND MAINTENANCE Periodically check the pen for signs of damage, wear, or missing components. Do not use if any part is missing, worn or damaged. Do not use abrasive cleaners or bleach. Clean with warm water and a mild detergent.
Page 16
Carlson Pet Products Inc. 3200 Corporate Center Drive, Suite 105 Burnsville, MN 55306, USA 952.435.1084 20210624ET...
Need help?
Do you have a question about the 2750 and is the answer not in the manual?
Questions and answers