Element ELCHS322 User Manual page 23

Appendix
Before calling a service technician, please check the foiiow(ng table for a possible cause of the problem and some
solutions,
Customer important notice: If the TV functions cannot be operated, unplug the AC cord from AC power
source, wait at [east 1 minute, then re-plug AC cord, This will reset the TV settings and should restore TV to
normal operation,
Symptoms
TV wi)[ not turn on
No picture, no sound
No sound, p)cture OK
Possible Solut(ons
Poor sound, picture OK
Poor picture, sound OK
The station may have broadcast difficulties. Try another channel.
Adjust the picture from the menu.
Unable to select a certa(n
The channel may be skipped. Choose this channel by dlrect(y selecting
channel
the buttons from the remote control.
=
Poor co[our or no colour
m
m
The remote control does
not operate o
=
=
Disorder display at power or
=
, Hake sure the power cord is plugged in, then press Power (Standby).
• The remote control batteries may be dead. Replace the batteries.
• Unplug the VGAwire and plug the power wire again.
• Check if you have set the timer off.
, Check the antenna/cable connections.
• Press [Display] to see if you have selected the right signal source.
The sound may be muted. Press [VOL+ ] on the remote control.
, The station may have broadcast difficulties. Try another channel.
• Check the speakers cable connections.
= Check if earphones are plugged into unit.
= The station may have broadcast difficulties. Try another channel
• Check the speakers cable connections.
• Check the antenna connections.
=
m
m
Remote control
programming
The station may have broadcast difficulties. Try another channel.
Adjust Saturation in the Video settings menu.
There may be an obstruction between the remote control and the
remote control sensor.
The batteries may be installed with a wrong polarity,
The remote control batteries may be dead. Replace the batteries.
This may be caused because of a very short interval between POWER
OFF and ON.
Unplug the power and restart.
Cable and Satellite content providers control the remote codes,
and we apologize for any confusion during the remote programming.
Please try the following codes 10019, 0178, 10178, 0030, 10030,
0835, 10835, or for Dish Network try 627,659 or 505. For Fios
TV (Verizon), try the code 3264. These codes may not work on some
universal remotes. If there is another code listed for Element
Electronics in your universal remote control guide, please try that
code. Refer to the Remote Control Guide under your TV's model
number for more information.
You may also visit us at www.etementetectronics.com to address any product use and performance
questions you may have
22