Table of Contents
Advertisement
Preparation
for using
your new TV
For subscribers to Basic Cable TV Se_ice
For basic cable service not requiring a Converter/Descrambler
box, connect the CATV 75 ohm Coaxial Cable
directly into the Antenna Jack on the back of the television.
For subscribers to Scrambled
Cable TV Service
If you subscribe to a cable service which requires the use of a Converter/Descrambler
box, connect the incoming
cable to the Converter/Descrambler
box and connect the output of the box to the Antenna Jack on the back of
the television. Follow the connections as shown below. Set the television to the output of the
Converter/Descrambler
box (usually channel 3 or 4) and use the Converter/Descrambler
box to select channels.
For Subscribers
to Unscrambled
Basic Cable with
Scrambled
Premium
Channels
If you subscribe to a cable service in which basic cable channels are unscrambled and premium channels require
the use of a Converter/Descrambled
box, you may wish to use a two-set signal splitter (sometimes referred to
as a two-set coupler) and an A/B Switch box from the cable installer or an electronics supply store. Follow the
connections shown below. With the switch in the B position, you can directly tune any unscrambled channels on
your TV. With the switch in the A position, tune your 1-V to the output of the Converter/Descrambler
box (usually
channel 3 or 4) and use the box to tune scrambled channels.
-
I
Convener/Descrambmer_
1
_
__
Splitter
AiB Switch_
Note:
When you use a converter
box with your TV, there may be features
that you cannot
program
when using the remote control.
11
Advertisement
Table of Contents
