Advertisement
Quick Links
Tools Needed
#3 Allen head for screen adjustments
#4 Allen head
#5 Allen head
#6 Allen head
Side cuts
15mm wrench or socket and 3/8 rachet
Torque Wrench
STEP 1
Start by cutting the outer shipping bands.
Carefully open the top lid to avoid any staple
ends.
Sidecuts
Sidecuts
Included
Manual
Battery
Charger
Keys speci c for battery
Advertisement
Related Manuals for ELEVATE HIGHRISE
Summary of Contents for ELEVATE HIGHRISE
- Page 1 Tools Needed Included #3 Allen head for screen adjustments Manual #4 Allen head Battery #5 Allen head #6 Allen head Charger Side cuts Keys speci c for battery 15mm wrench or socket and 3/8 rachet Torque Wrench STEP 1 Sidecuts Sidecuts Start by cutting the outer shipping bands.
- Page 2 STEP 2 Remove the accessories box and seat box. STEP 3 Remove the bike from the box Note: Due to the packing, an assistant might be needed for this step. STEP 4 Discard the Disc Brake shipping cover. STEP 5 Sidecuts Sidecuts Using Sidecuts, remove the zip ties from the...
- Page 3 STEP 6 Carefully remove the front tire from the bike by sliding it directly forward, to avoid damaging the spokes or pedal arm. Then remove the front fender from the tire and set both aside. STEP 7 Remove the Seat and Seat post from packaging material.
- Page 4 STEP 10 Remove the rest of the protective packaging along with packaging on handlebars. Note: If possible, avoid using a razor blade. STEP 11 Sidecuts Sidecuts Remove the bike keys using a pair of Sidecuts. These are normally attached to the front handlebar harness or rear motor.
- Page 5 STEP 14 Tighten the bolts to 7 newton meters in a criss cross pattern to evenly secure the bolts. Note: Final adjustments can be made after assembly. STEP 15 #5 Allen head #5 Allen head To install the front headlight and fender, remove the front shock bolt with a 5mm allen socket and retain.
- Page 6 STEP 18 #5 Allen head #5 Allen head Tighten the front shock bolt to 90%, then adjust the two componenets so they are square. Then nish tightening until to 7 newton meters. STEP 19 #4 Allen head #4 Allen head With a 4mm allen head socket, remove the bolts from the bottom of the front forks.
- Page 7 STEP 22 15mm wrench 15mm wrench Loosen the wheel nuts and washers to almost the last threads of the wheel, leaving enough room for the mounting arm to slide on. When adding air to the tires, be sure to Note: match psi levels with what is inscribed on the tire.
-
Page 8: Battery Removal
BATTERY REMOVAL STEP 26 To remove your battery insert the key into the mount and turn clockwise. Then pull the battery free from the bike. With the battery removed, check your battery’s state of charge by pressing the red button. Note: Make sure the power button is switched ON Power Switch... - Page 9 STEP 27 The charge port is located on the left hand side of the bike. Note: You do not have to remove the battery to charge the bike. Charge before using the bike even if the screen is showing full battery charge (5 bars).
Need help?
Do you have a question about the HIGHRISE and is the answer not in the manual?
Questions and answers