Cub Cadet 1782 Owner's Manual page 10

i
M. TURNING BRAKE LOCK
A
CAUTION
Turning brake pedals should not be used
when mowing lawns. The wheel being
braked may skid and cause lawn damage.
Turning brake pedals should be locked
together.
Hl^ NOTE
Turning brake pedals must be latched
together when operating the tractor in trans¬
port speeds.
The turning brake lock is located in the top edge of the
outside turning brake pedal (see Figure 6) and is used
to lock the two turning brake pedals together to pro¬
vide simultaneous braking to both rear wheels when
the turning brake pedals are depressed. To lock the
pedals together, pivot the lock and engage it in the slot
on the inside turning brake pedal. For individual brake
action, pivot the lock into the storage slot in the out¬
side turning brake pedal.
If the turning brake pedals are not locked together and
the single brake pedal is used, only the left rear tractor
wheel is slowed or stopped.
Figure 6
1. Turning Brake Pedals
2. Turning Brake Lock
N. TILT WHEEL RELEASE LEVER
The tilt wheel release lever is used to adjust the steer¬
ing wheel forward away from the operator or rearward
towards the operator. Refer to ADJUSTING THE
STEERING WHEEL in Section III.
O. IGNITION SWITCH
The ignition switch is a four-position switch. The igni¬
tion key is turned to "GLO-PLUG" position before it is
turned to "START." Refer to "GLO-PLUG INSTRUC¬
TIONS" on page 17 for explanation of this feature.
Turn key to start position. When engine starts,
release key. Key will retract to "ON" position. (See
Figure 7.)
A
WARNING
Remove the key from the tractor when the
tractor is not in use to prevent accidental
starting and battery discharge.
■^NOTE
Under certain conditions it is possible for a
diesel engine to start and run in a reverse
condition.
Figure 7
P. LIGHT SWITCH
The lights are turned on and off by a toggle switch on
the lower left hand side of the instrument panel. (See
Figure 3.) Flip switch to the right for "ON", to the left
for "OFF".
Q. LIFT HEIGHT INDICATOR
The lift height indicator will indicate the height of deck
attachment when installed. (See Figure 8.)
LIFT HEIGHT
INDICATOR
10
Figure 8