Whirlpool AWM 8161 Quick Start Manual page 12

3gb10144.fm Page 29 Tuesday, September 7, 2004 12:54 PM
a.Water inlet fault (no or insufficient
water supply)
The "Water tap" indicator is on or the display
alternately shows "FH". Switch off the appliance by
turning the programme selector to the "
position and unplug it.
Check wheter:
• the water tap is completely open, and the water
supply pressure is sufficient;
• the water inlet hose is kinked;
• the mesh filters are blocked (see "Care and
Maintenance" / "Water Hose Mesh Filters");
• the water inlet hose is frozen.
Connect the appliance to the electrical supply.
Reselect the desired programme and press the "Start/
Pause" button again to continue with the programme
(do not add detergent for this programme).
b.Draining out fault
The display alternately shows "FP". Switch off the
appliance by turning the programme selector to
the " " position and unplug it.
Check whether:
• the drain hose is kinked (see "Installation
Instructions");
• the pump / filter are blocked (see "Removing the
Filter / Draining Residual Water").
IMPORTANT: before draining, allow the wash
water to cool down.
• the drain hose is frozen.
Connect the appliance to the electrical supply.
Reselect the desired programme and press the "Start/
Pause" button again to continue with the programme
(do not add detergent for this programme).
If the fault re-occurs, contact After-Sales Service
(see "After-Sales Service").
Black process 45.0° 100.0 LPI
c. Electrical module fault
The display shows "F4" to "F15".
• Switch off the appliance. Select a programme and
press the "Start/Pause" button once again.
The programme will continue.
"
• If the fault re-occurs, contact After Sales Service
(See "After-Sales Service").
d.Water Stop fault (if available)
An audible tone sounds. The light of the Water
Stop indication is on.
The display shows "FA" and the pump is running.
Switch off the appliance by turning the programme
selector to the "
and make sure that the water tap is closed.
The "Water Stop" may have been triggered
by:
1. too much foam.
2. a leak in the inlet hose or in the appliance.
Tilt the appliance forwards carefully to allow the
collected water to flow out.
Then:
1. connect the appliance to the electrical supply,
2. open water supply to machine (if "Start/Pause"
button is not pressed, but machine begins to fill,
close water supply and call After-Sales Service),
3. reselect the desired programme and press the
"Start/Pause" button (there is no need to add
additional detergent). The programme will
continue.
If the faults occurs again, call After-Sales Service with
details about the fault (see "After-Sales Service").
" position, unplug the appliance
29