Table of Contents
Advertisement
Page 14
6-32x3/8" SCREW
Detail 8A
CONTROL PANEL MOUNTING AND WIRING
For best operation of the Amplifier, all wire
should be positioned neatly. Refer to the Chassis
Photos (fold-out from Page 38) which show how a
completed kit should look.
( ) Position the chassis and control panel as
shown in Detail 8A. Secure the control panel
to the chassis with 6-32 x 3/8" hardware.
NOTE:
The
large black hookup wire is quite
similar to the shielded cable. Remove 1/4" of
insulation from one end of each of these wires;
then be sure you choose the shielded cable (with
the foil inner wrap) for the next step. Also, do
not confuse the 2-conductor (two inner leads and
a shield) shielded cable with the single conductor
(one inner lead and a shield) shielded cable. The
2-conductor shielded cable should only be used
for the wiring of the foot switch.
( ) Refer to Detail 8B, and prepare the ends of
a 10" length of single conductor shielded
cable.
PREPARE
EACH
END
AS SHOWN
1 1/2
1/
4
"
r
/
1
2"
1,..-
1/4"
SHIELD
LEAD
TAKING CARE
NOT
TO CUT
THE
VERY
THIN WIRES
OF
THE
SHIELD
LEAD,
REMOVE
THE
OUTER
INSULATION.
PEEL
OFF
THE
FOIL
AND
STRAIGHTEN OUT
THE
THIN WIRES OF
THE
SHIELD
LEAD.
FOIL
1
SHIELD
LEAD
REMOVE
THE
INNER
INSULATION AND
TWIST
THE
SMALL
WIRES OF
THE
SHIELD
LEAD,
APPLY
SMALL
AMOUNTS OF
SOLDER
TO THE
END OF
THE
SHIELD
LEAD
AND
THE
INNER
LEAD.
SOLDER
Detail 8B
TWIST AND
SOLDER
Advertisement
Table of Contents
