Advertisement
Precautions
« This system cannat be used with a car audio
without the facility to receive FM.
Before operating the unit for the first time or
alter replacing the car battery, press the reset
button on the hideaway unit with a ball-point
pen ete., and then start operating the system.
«If vour car was parked in direct sunlight
resulting in a considerable rise in temperature
inside the car, allow the system to cool off
before operating it.
If no power is being supplied to the system,
¢ Avoid installing the system in places:
-— subject to temperatures exceeding 53°C
— subject to direct sunlight.
— near heat sources (such as heaters).
— exposed to rain or moisture.
— exposed to excessive dust or dirt.
— subject to excessive vibration.
As the laser beam used in this compact disc
changer is harmful to the eyes, do not attempt
to disassemble the cabinet. Refer servicing to
qualified personnel only.
check the connections first. If everything is in
order, check the fuse.
CAUTION
|
The use of optical instruments with this product will increase eye hazard.
The shielded interface cable recommended in this manual must be used with this equipment in
order to comply with the limits for a digital device pursuant to Subpart B of Part 15 of FCC Rules.
INFORMATION
'This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation, This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
mays cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
— Reorient or relocate the receiving antenna.
—
increase the separation between the equipment and receiver.
~- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
— Consult the dealer or an experienced radio/TY technician for help.
You are cautioned that any changes or modifications not expressly approved in this manual could
void vour authority to operate this equipment.
i
Advertisement
