Yamaha AG200FED 2012 Owner's Manual page 68

PERIODIC MAINTENANCE AND ADJUSTMENT
2 3
1
(a)
2
1
3
1. Rubber cover
4
2. Brake lever free play adjusting bolt
3. Locknut
5
5. Disconnect the brake cable from
the front brake lever, then from the
6
brake camshaft lever.
1
7
8
9
2
1. Brake cable
2. Brake camshaft lever
3. Axle nut
6. Loosen the axle nut.
7. Lift the front wheel off the ground
according to the procedure in the
previous section "Supporting the
motorcycle".
8. Remove the axle nut, pull the
wheel axle out, and then remove
the wheel.
To install the front wheel
1. Install the brake shoe plate into the
wheel hub as shown.
3
2. Lift the wheel up between the fork
legs.
TIP
Make sure that the slot in the brake
shoe plate fits over the retainer on the
fork leg.
EAU35042
1. Brake shoe plate
2. Slot
3. Retainer
7-33
2
1
3. Insert the wheel axle from the right
hand side, and then install the axle
nut.
4. Lower the front wheel so that it is
on the ground.
5. Connect the brake cable at the
brake shoe plate and then at the
handlebar lever holder.
6. Connect the speedometer cable
and install the clip.
7. Tighten the axle nut to the speci-
fied torque.
Tightening torque:
Axle nut:
39 Nm (3.9 m·kgf, 28 ft·lbf)
3