Table of Contents
Advertisement
3. Disassembly and Reassemble
Description & Screws
6
Remove the DC VSS-PD BOARD.
(Please follow 5 sequence on right.)
CAUTION
Plz discharge SMPS before disconnect SMPS.
And Refer to available touch point.
A
<You can see
3-10
Before SMPS
disconnect, Use
discharge Jig on
this point for SMPS
discharge.
A
B
B
B
B
A
A
silk for touch>
Point A : Can touch (2nd
GND & NO materials)
Point B : Don't touch (1st
Importand materials)
Picture Description
1.
Remove power connector.
2.
Push and hold down BLU Connector Tab to release its
panel lock connection.
3.
Lift to Release the Lock Tab on Upper left side of
Board (Step 5 will assist).
4.
Locate a notch in insulation sheet (not all models).
5.
Use Open Tool in notch to help release & smoothly
slide SMPS Board to the Right. (While pushing BLU
Tab & Releasing Lock Tab)
Advertisement
Table of Contents
