Table of Contents
Advertisement
4. Troubleshooting
4-3. Factory Mode Adjustments
4-3-1 Entering Factory Mode
To enter 'Service Mode' Press the remote -control keys in this sequence :
- If you do not have Factory remote - control
Power OFF
4-3-2 How to Access Service Mode
Using the Customer Remote
1.
Turn the power off and set to stand-by mode
2.
Press the remote buttons in this order; POWER OFF-MUTE-1-8-2-POWER ON to turn the set on.
3.
The set turns on and enters service mode. This may take approximately 20 seconds.
4.
Press the Power button to exit and store data in memory.
- If you fail to enter service mode, repeat steps 1 and 2 above.
5.
Initial SERVICE MODE DISPLAY State
Mode: CDTV . RES : 480I
Option
ADC/WB
Control
Expert
Advanced
6.
Buttons operations withn Service Mode
Menu
Direction Keys
/
Direction Keys
/
Source
4-26
INFO
MENU
T-CHELEU-****
T-CHU7AEAC-****
T-CHU7DEUS-****
SDAL-4.2.26-0133
RFS:22_2G_64_512-13 T-CHU7DEUC
2009-01-30
FRCQ FW : 0502, CONFIG : 4800
Type : 40A 1UFOE
Model: UN**B7000
MAC SUCCESS
EDID SUCCESS
CALIB : AV O COMP O PC 0 HDMI O
Option : 0751 a014 280
Factory Data Ver : 453
DTP-AP-COMP-110
DTP-HIIG-0104
TLIB 7000 MAEA 2G 2009-01-16-01
DTP-BP-0113
Date of purchase : **/**/****
Full Menu Display/Move to Parent Menu
Item Selection by Moving the Cursor
Data Increase / Decrease for the Selected Item
Cycles through the active input source that are connected to the unit
MUTE
Power On
Advertisement
Table of Contents
