Advertisement
BASIC OPERATIONS
Press the power switch on the side panel to the ON position. The LED's on the operation panel light up as shown and the unit is
now in initial mode for operation.
DIGITAL
Digital AV Mixer Wd-AVET
A. Input Signal Selection and Back Colour Selection
1 Slide the Mix/Wipe Control to the A-bus
position.
The
MixWipe
LED's
fight or blink according to the
position of the Mix/Wipe Control.
MUX WIPE EFFECT/FADE CONTROL
2 Press any of the SOURCE 1, SOURCE
2, EXT CAMERA and BACK COL.
buttons.
You willsee each picture on the screen.
Mix/wipe
3 Press a BACK COL. button.
tED
The LED on the other button, which was selected last
time, starts blinking.
Note: Any of the 8 back colours - White, Yellow, Cyan,
Green, Magenta, Red, Blue and Black - can be
selected by repeatedly pressing either of the Back
Colour Selection Buttons.
The same procedures apply to the B-bus.
Back Colour
Selection Button
-11-
B. Video Mix
MIX WIPE EFFECT/FADE CONTROL
Reset the operation panel to initial mode.
1 Press the MIX button.
2 Press one of the A-bus Selection
Buttons.
3 Press one of the B-bus Selection
Buttons.
4 Operate the Mix/Wipe Control.
Sharp edge
A bus
B bus
Wide edge
PA
ne Faint edge
A bus
B bus
ee
Compiementary colour
242:
Reset the operation panel to initial mode.
1 Press one of the A-bus Selection
Buttons.
2 Press one of the B-bus Selection
Buttons.
3 Operate the Mix/Wipe Control.
Mi Wipe Edge
Press the WIPE/EDGE button repeatedly.
Three kinds of edges are available:
Sharp edge, Wide edge, Faint edge
Note: If the Wide edge is selected, you can add a
complementary back colour to the edge using the
Back Colour Selection Buttons.
Advertisement
