Tobii Pro Spark User Manual page 19

For this we could recommend the Flex Mount, which is designed to fit most screen
shapes and forms as you can adjust the angle of the Flex Mount to ensure that the eye
tracker can always face you.
Some laptops are very thin and there is little space between the screen and the key-
board when the laptop is closed. We recommend that you check whether the laptop
can close with the mounting bracket present before you attach it.
What to do:
1. Make sure the eye tracker is attached to the monitor and connected to your computer.
Open Tobii Pro Eye Tracker Manager. You should be able to see and expand your eye
tracker's "card" in Tobii Pro Eye Tracker Manager. The serial number of your eye tracker
should match the number displayed.
2. You can leave your eye tracker USB cable connected with the eye tracker to the side (for
example on the table) or you can disconnect it while you attach the mounting bracket.
3. If you plan to attach the eye tracker to a laptop, make sure the laptop can close with the
magnetic mounting bracket attached. Some laptops have very little space when closed.
You can test whether you can close the laptop with the mounting bracket by pla-
cing the mounting bracket (with the backing paper still attached) on the key-
board side of the laptop and carefully closing the laptop lid. Watch for any
potential interference between the screen, bracket, and keyboard.
4. Find the center of the screen and clean the bezel with one of the included cleaning wipes.
5. Peel the adhesive tape off the mounting bracket and mount it on the bezel so that your Tobii
Pro Spark is as close to the bottom of the screen as possible without covering the screen.
Press the bracket against the bezel for 30 seconds and wait one hour before attaching the
eye tracker.
6. Attach the eye tracker, making sure that it aligns properly with the mounting bracket. The
magnet holds the eye tracker firmly in place when the slots are lined up correctly.
7. If it is not yet connected, plug in the eye tracker's USB cable to the correct USB port in your
computer.
8. Move to the next step.
Tobii Pro Spark User Manual v. 1.2
Figure 3. Mounting brackets with non-permanent adhesive
19