Table of Contents
Advertisement
❑
❑
❑
❑
Be sure to register your warranty at www.paradyne.com/warranty.
Cables You Need
Each of the POTS/ISDN splitter card interfaces in the 5920 chassis requires three
50-conductor cables with 50-pin Telco connectors. If every slot is populated and
used, you require:
Use a minimum of 24 AWG (0.205 mm
Preparation
The installation location should be well ventilated, clean, and free of environmental
extremes. Allow clearance at the front of the POTS splitter chassis to provide
access to the cables.
Read the
Tools Required
2
Installing the POTS splitter chassis
Installing splitter cards in the chassis
Connecting the cabling from the POTS splitter card connectors to the BLC
(Broadband Loop Carrier), local loop, and in-building wiring
Securing the cables
6 cables for the Model 5920-B1-048
18 cables for the Model 5920-B1-144
24 cables for the Model 5920-B1-192
54 cables for the Model 5920-B1-432
HANDLING PRECAUTIONS FOR
!
STATIC-SENSITIVE DEVICES
This product is designed to protect sensitive components from damage
due to electrostatic discharge (ESD) during normal operation. When
performing installation procedures, however, take proper static control
precautions to prevent damage to equipment. If you are not sure of the
proper static control precautions, contact your nearest sales or service
representative.
Important Safety Instructions
A medium #2 Phillips screwdriver to tighten the POTS/ISDN splitter card
fasteners.
A large #3 or #4 Phillips screwdriver to install the chassis into a rack.
A flat-blade screwdriver to fasten cable heads.
May 2005
2
).
on page 9.
5920-A2-GZ40-00
Advertisement
Table of Contents
