Samsung UN32B6000VFXZA Service Manual page 86

4. Troubleshooting
4-4-3 White Balance - Adjustment
ADC/WB White Balance
4-5. Servicing Information
4-5-1 Upgrading the Software
Samsung may offer upgrades for TV's firmware in the future. Please contact the Samsung call center at 1-800-
SAMSUNG (726-7864) to receive information about downloading upgrades and using a USB drive. Upgrades will
be possible by connecting a USB drive to the USB port located on your TV.
1. Insert a USB drive containing the firmware upgrade
into the Wiselink Pro port on the side of the TV.
2. If pop up is showed, press the exit or or press the
No button. (If you press Yes button, display is changed
to Wiselink Pro Menu)
3. Press the MENU button to display the menu.
Press the ▲ or ▼ button to select "Setup", then press
the ENTER button.
4. Press the ▲ or ▼ button to select "SW Upgrade",
then press the ENTER button.
5. Press the ENTER button.
The message "Scanning for USB... It may take up to
30 seconds." is displayed.
6. The message "Upgrade version XXXX to version XXXX?
The system will be reset after upgrade." is displayed.
Press the ◄ or ► to select the "OK", then press the
ENTER button.
Please be careful to not disconnect the power or
remove the USB drive while upgrades are being applied.
The TV will turn off and turn on automatically after
completing the firmware upgrade. Please check the
firmware version after the upgrades are complete.
When software is upgraded, video and audio settings
you have made will return to their default (factory)
settings. We recommend you write down your settings
so that you can easily reset them after the upgrade.
4-38
(low light)
Sub Bright
R offset
G offset
B offset
(W/B adjustment Condition refer next page)
(hight light)
Sub Contrast
R gain
G gain
B gain