Table of Contents
Advertisement
GENERAL REMARKS
|
e
Before disassembling the unit, spread a soft rubber mat ora
Battery
* Compartment Lid-
cloth on the workbench to avoid scratches and grease stains.
Do
not
use
a material
which
is likely to cause
static
| direction of the arrow.
e
CABINET TOP REMOVAL
1.
Remove the three screws (7 ~ 9). After lifting up the cabinet
Top lightly in the direction of the arrow (1), slide it in the
direction of the arrow (2).
Once again, slide the Cabinet Top in the direction of the
arrow (3) while lifting it. When the Cabinet Bottom and
Cabinet
Top
is removed,
the
Cabinet
Mic.
and
Mic.
Sensitivity Knob can be detached from the unit.
@
electricity because the transistors and ICs may be easily
damaged by it.
©
When
mounting the P.C.Board; confirm that the leads,
resistors,
capacitors,
etc.,
do not
contact
the function
mechanism such as gear or belt. Also refer to the Exploded
Views.
?
ey stems
ve FF
@
Reassemble the unit, noting the kinds, of-serews, the:
soldering and arrangement of the leads. Refer to' "Circuit ©
Diagram and Exploded Views' for correct assembly.
-e@
Before disassembling the unit, take out the cassette tape
and the batteries.
@
Reassemble in reverse order.
CABINET BOTTOM REMOVAL
1.
Remove the six screws (1 ~ 6) fastening the Cabinet Bottom
and open the Battery Compartment Lid.
2.
Carefully detach
the Cabinet
Bottom
by lifting it in the
AMPLIFIER FPC REMOVAL
"
FRAME REMOVAL
V
Advertisement
Table of Contents
