Advertisement
Page 26
2V2
PLACE
IN DIAL DRUM
GROOVE
Figure 20
Figure 20A
(
Insert the pointer between the plastic dial
and
dial back plate at the dial drum end
and slide the pointer over the lip of the dial
back plate. See Figure 20B,
Figure 20B
A with the
MAIN
TUNING
capacitor
fully
meshed, position the pointer over the verti-
cal line at the beginning of each band marking
and crimp the ears over the dial cord. Do not
use too much pressure or the ears may cut
the dial cord. See Figure 20C.
'ey,
Figure 20C
By turning the TUNING capacitor shaft, position
the pointer all the way tothe right end of the dial,
Be sure the pointer ears hit the dial drum. This is
the right edge pointer stop, F the pointer ears
do not hit the center of the dial drum, reposi-
tion the dial drum onthe TUNING capacitor shaft
so they do,
(
Mount
the meter
in the position shown
in
Pictorial 2, The positive (+) lug goes toward
the dial drum,
Hold the meter against the
panel,
and slip the clamp over the rear of
the meter,
With a screwdriver,
push both
sides
of
the
clamp
tightly
against
the
panel as shown in Figure 21,
NOTE:
To
prevent
the
clip from filling with
solder when soldering a wire to it, grasp the
Advertisement
