Model 3 Power Frunk installation instruction
Usage
Hood button
Open
single click
Close
**
Note: Installation instruction may differ slightly from the actual operation, if different,
please operate according to the actual situation or contact us.
operating instruction
一:Height adjustment
Adjust the hood to the right height, long press the reset button of the main box for 5 seconds,
and hear a long beep, the height setting succeed, when opened again will be the set height.
二:Speed Adjustment
Adjust the hood to the right height, long press the reset button of the main box for 5 seconds,
and hear a long beep, the height setting succeed, when opened again will be the set height.
**
The hood switch speed has 5 gears, default 4th gear, minimum 2nd gear, maximum 6th gear.
Press and hold the reset button of the main box, when you hear the buzzer sound 2 times in a row,
it means the speed is set 2 gears successfully, and so on.
Power frunk special fuse
(match 25A )
plug in the original vehicle
(no fuse,no plug)
Power inlet
Phone
single click
/
single click
Model 3 Power Frunk installation instruction
Ensure the inlet connected to the
commonly usedoriginal vehicle fuse hole
with power,otherwise, the original fuse
overcurrent willfuse,measure with a test
pencil before installation to ensure the
power inlet.The current direction is
shown as the red line in the diagram
Power inlet
Power outlet
Center console screen
Key
double click
double click
Technology Center - Technical Service Department
single click
single click