Yuxi Space Y Installation Instructions

Model Y Power Frunk installation instruction
Ensure the inlet connected to the commonly usedoriginal vehicle fuse hole with power,therwise,
the original fuse overcurrent will fuse,measure with a test pencil beforenstallation to ensure
the power inlet.The current direction is shown as the red line inthe diagram
Usage
Hood button
Open
single click
Close
**
Note: Installation instruction may differ slightly from the actual operation, if different,
please operate according to the actual situation or contact us.
operating instruction
一：Height adjustment
Adjust the hood to the right height, long press the reset button of the main box for 5 seconds,
and hear a long beep, the height setting succeed, when opened again will be the set height.
二：Speed Adjustment
The frunk switch speed has 5 gears, the default 4th gear, the lowest 2nd gear, the highest
6th gear. Press and hold the frunk button, when you hear the buzzer sound 2 consecutive
times, it means the speed setting 2nd gear successfully, and so on.
**
After the installation is completed, the decoder plugged into the power: need to adjust the hood
to the highest, press and hold the hood addition button for 5 seconds. The matching operation is
completed when loosing the button after a long beep （Re-powering requires re-operation）
Note：unspecified cables are not installed
Phone
single click
/
single click
Model Y Power Frunk installation instruction
Power inlet
Center console screen
Key
double click
double click
Technology Center - Technical Service Department
Power outlet
single click
single click