Table of Contents
Advertisement
en Troubleshooting
Fault
"E:35 / -10"
"E:30/-20"
All other error codes.
The appliance is not
working.
46
Cause and troubleshooting
There is water in the base trough.
Turn off the water tap.
▶
Call the after-sales service.
▶
→ "Customer Service", Page 55
The appliance is leaking.
Turn off the water tap.
▶
Call the after-sales service.
▶
→ "Customer Service", Page 55
Detergent dosage is too high.
Immediate measure: Mix one tablespoon of fabric
▶
softener with 0.5 litres of water and pour the mix-
ture into compartment II (not for outdoor clothing,
sportswear or items stuffed with down).
Reduce the amount of detergent for the next wash-
▶
ing cycle with the same load.
Drum cleaning is required.
→ "Cleaning the drum", Page 39
▶
Detergent dosage is too high.
Reduce the amount of detergent for the next wash-
▶
ing cycle with the same load.
Additional water is added.
Do not add any extra water to the appliance while it
▶
is operating.
Solenoid valve defective.
Call the after-sales service.
▶
→ "Customer Service", Page 55
Malfunction
Switch the appliance off and then on again.
1.
If the message appears again, disconnect the appli-
2.
ance from the power supply for at least 30 seconds
by pulling out the plug or by switching off the relev-
ant circuit breaker in the fuse box.
a If the fault was a one-off, the message disappears.
If the message appears again, call the after-sales
3.
service. Please specify the exact error message
when calling.
→ "Customer Service", Page 55
The mains plug of the power cord is not plugged in.
Connect the appliance to the power supply.
▶
The circuit breaker in the fuse box has tripped.
Advertisement
Table of Contents
