EN
Assembly The Grass Catcher
1. To fit: Raise the rear cover and hitch the grass catcher on rear of mower. (Fig.3A/Fig.3B/Fig.3C)
2. To remove: grasp and lift the rear cover, remove grass catcher.
Level indicator (not included in all models)
There is a level indicator on the top of the grass catcher that shows whether the catcher is empty or full :
- The level indicator inflates if the catcher is not full during the moving. (Fig. 3E)
- If the catcher is full, the indicator collapses; once this happens, stop moving immediately and empty the catcher, make sure it is clean and
ensure its mesh-work is ventilated. (Fig. 3D)
Important:
If the position of indicator opening is very dirty, the indicator will not inflate-in this case, clean the position of indicator opening
immediately.
Fig.3A
Fig.3D
6. Adjustment Of Cutting Height
Apply outward pressure to disengage lever from rack. Move lever forward or back to adjust height.
The height (the blade to the ground) can be adjusted from 20mm (position 1) to 70mm (position 6), 6 height positions. All
wheels will be in the same height of cut.
Fig.4A
6
Fig.3B
Fig.3E
Fig.4B
WWW.NAKAYAMATOOLS.COM
Fig.3C
WARNING: Make this adjustment only when
the blade is stopped.
WARNING: Disconnect the electric cord from
the power supply.