Advertisement
safety information
• In order to avoid the creation of a flammable gas-air mixture if a leak in the refrigerating circuit
occurs, the size of the room in which the appliance may be sited depends on the amount of
WARNING
refrigerant used.
• The room must be 1m 3 in size for every 8g of R600a refrigerant inside the appliance.
• Never start up an appliance showing any signs of damage. If in doubt, consult your dealer.
• Please dispose of the packaging material for this product in an environmentally friendly
manner.
• Don't replace parts of the refrigerator.
• keep ventilation openings,in the appliance enclosure or in the built-in structure , clear of
obstruction.
• Do not use mechanical devices or other means to accelerate the defrosting process ,other
than those recommended by the manufacturer.
• Do not damage the refrigerant circuit.
This warning is only applicable to appliances whis refrigerating circuits which are accessible
to the user.
• Do not use electrical appliances inside the food storage compartments of the appliance,
unless they are of the type recommended by the manufacturer.
• Do not store explosive substances such as aerosol cans with a flammable propellant in this
appliance.
SEVERE WARNING SIGNS
• Do not install the refrigerator in a damp place or place where it may come in contact with
water.
WARNING
- Deteriorated insulation of electrical parts may cause an electric shock or fire.
• Do not place this refrigerator in direct sunlight or expose to the heat from stoves, room
heaters or other appliance.Don't put burning wax candle or fireworks on the refrigerator.
- Otherwise, it will result in hazards of electric shock and fire.
• Allow sufficient space to install the refrigerator on a flat surface.
- If your refrigerator is not level, the internal cooling system may not work correctly.
• Use only 220~240V power. Do not plug several appliances into the same multiple power
board. The refrigerator should always be plugged into its own individual electrical which has a
voltage rating that matched the rating plate.
- This provides the best performance and also prevents overloading house wiring
circuits,which could cause a fire hazard from overheated wires.
• Never unplug your refrigerator by pulling on the power cord. Always grip plug firmly and pull
straight out from the outlet.
- Damage to the cord may cause a short-circuit, fire and/or electric shock.
• Make sure that the power plug is not squashed or damaged by the back of the refrigerator.
• Do not bend the power cord excessively or place heavy articles on it.
- This constitutes a fire hazard.
• Do not use a loose socket or a cord that shows cracks or abrasion damage along its length
or at either end.
• If the power cord is damaged, have it replaced immediately by the manufacturer or its service
agent.
• When moving the refrigerator, be careful not to roll over or damage the power cord.
• Do not insert the power plug with wet hands.
• Remove any foreign matter or dust from the power plug pins.
- Otherwise there is a risk of fire.
• If the refrigerator is disconnected from the power supply, you should wait for at least ten
minutes before plugging it back.
• If the wall socket is loose, do not insert the power plug.
- There is a risk of electric shock or fire.
• The appliance must be positioned so that the plug is accessible after installation.
• Do use separate and reliable earthing power. Don't share a socket with other appliances.
In order to ensure safety, the socket and its connecting wire must be able to bear over 10A
current.
04_ safety information
Advertisement
