Zenith IQD61W20 Operating Manual page 35

GUIDE Plus+ System Connection
Locate the jack marked G-LINK.
1
This jack is for the IR
Cord connection. Insert the
connector into the G-LINK.
Place the other end of the
2
cords with the IR (Infrared)
emitter sending units in
front of your VCR and Cable
Box in such a way as to
allow for an unrestricted
path for the IR signals to be
able to reach the front pan-
els of the VCR and Cable Box.
If necessary, peel off the
green protective strips from
the front and back of the IR
emitter to hold emitter in
proper location.
In order to receive the GUIDE
Plus+ signal, it is necessary to
connect your TV through the
Antenna/Cable #1 jack on the rear
of the TV.
206-3674
IR receiver
IR emitter
G-LINK
L
G-LINK
R
IR emitter
RGB IN
Cable Box
17
IR receiver
VCR
P A G E 3 5