Setting Add/Delete/Blank - Zenith H25F36DT Installation And Operating Manual, Warranty

Setting Add/Delete/Blank

Fine-tune the guest's channel selection list
1
Press the MENU key on the Installer's remote so the Setup
menu appears.
2
Press SELECT repeatedly to highlight the Add/Del/Blnk
option.
3 Using either the NUMBER keypad and ENTER or the
Channel Up/Down arrow on the remote, select a channel.
(If adding a deleted channel, you will need to use the
NUMBER keypad and ENTER.)
4
Using the Right/Left ADJ arrow, specify whether that
channel is Added, Deleted, or Blank.
5
To continue, select another channel and repeat Step 4.
When you are finished, press ENTER to remove menu.
Adding Aux, VCR 3, VCR 4, to the Channel
Preview List
Go to the Setup menu, select the Add/Del/Blnk option.
Use Channel Up/Down to select the option and choose
Added.
Note: If the option was turned off in the Service menu,
you will have to reinstate it before it can appear as an
option in the Channel Preview list.
Note: You can specify Add, Delete or Blank for VCR3,
VCR4, and Aux. Caution: If you delete CH3, VCR3 is also
deleted, if you delete CH4, VCR4 is also deleted and vice
versa.
If you delete a channel, it isn't gone for good. Just select it using
the NUMBER keypad on the remote, or add it later.
Mini glossary
ADD Adds new channels to the list that the guest can scroll through when using the remote.
DELETE Removes channels for one reason or another from the list that the guest can scroll through.
BLANK Removes the video signal from a channel so the guest will only receive the audio signal.
206-3751
SETUP MENU
AUTO PROGRAM
ADD/DEL/BLNK CH 44 ADDED
CH. LABELS
CLOCK SET
TIMER
CAPTIONS
LANGUAGE
2
1
4 5
3
7 8
0
ENTER
TIMER MENU
SELECT
2
ADJ
4
3
3
6
9
3/5
1
ALARM
CH PREVIEW
ADJ
P A G E 1 7