Antenna; Antenna Hook Up - Zenith H25E37Y Installation And Operating Manual, Warranty

Zenith h25e37y: operating guide
Table of Contents

Advertisement

Antenna Hook Up

Connect an over-the-air antenna to
the Concierge TV
1
Locate the Antenna/Cable jack on the back of the
Concierge TV.
2
Connect the antenna wire that runs from the wall,
according to one of the diagrams to the right.
3
Remove the back of the remote and put in two AA
batteries.
4
Plug in the TV. The Entertainment Machine is
designed to operate on standard current, 120-volt
60 Hertz AC. Do not attempt to operate it on DC
power.
120 V AC
60 Hz
5
Go to page 11 to Auto Program the TV.
If you have a 75 ohm RF cable, then you don't need any
adapters!
A 300 to 75 ohm adapter is not included with the Zenith
Concierge TV.
Mini glossary
75 OHM RF CABLE
The wire that comes from an off-air antenna or cable service provider. Each end looks like a hex shaped nut with a wire
sticking through the middle, and it screws onto the threaded jack on the back of your TV.
300 TO 75 OHM
A small device that connects a two-wire 300 ohm antenna to a 75 ohm RF jack. They are usually about an inch long with two screws
on one end and a round opening with a wire sticking out on the other end.
ADAPTER
P A G E 6
back of
remote

Antenna

Flat Wire
(300 ohm)
TV Back Panel
300/75 ohm
(Expanded View)
Adapter
TV Back
Antenna
RF Coaxial Wire
(75 ohm)
TV Back Panel
(Expanded View)
TV Back
ANTENNA
CABLE
VIDEO
SPEAKER
OUT
IN
AUDIO
IN
ANTENNA
CABLE
VIDEO
SPEAKER
IN
OUT
AUDIO
IN
206-3745

Advertisement

Table of Contents
loading

This manual is also suitable for:

Concierge h25e39y

Table of Contents