Advertisement
Quick Links
WPA2 Antenna
The WPA2 antenna is designed to mount inside your vehicle when you are not using
a traditional fender mount antenna.
Installation
1. Place the main body of the WPA2 as high in the dash as possible or using the
adhesive backing secure to the upper windshield or rear glass. Avoid placing it
near any high-current wiring.
Glass installation: Clean the mounting area with an alcohol wipe. Using a lint-free rag,
clean any residue off the window. Peel backing off the adhesive strip and press firmly to
the glass surface. Be careful not to press too hard on windshield applications.
2. Route the antenna cable with the thin black power wire to your radio location.
Connect the thin black wire to a 12-volt ignition source or the blue power antenna
output wire of your RetroSound® radio.
3. Connect the male antenna plug into the female antenna receptacle of your radio.
Installation Guide
retromanufa ct ur i ng
.
www
WPA2
Enhanced Amplified
Hide-away Antenna
.c om
Advertisement
Related Manuals for RetroSound RetroAntenna WPA2
Summary of Contents for RetroSound RetroAntenna WPA2
- Page 1 2. Route the antenna cable with the thin black power wire to your radio location. Connect the thin black wire to a 12-volt ignition source or the blue power antenna output wire of your RetroSound® radio. 3. Connect the male antenna plug into the female antenna receptacle of your radio.
- Page 2 Warranty Your unit comes with a manufacturer's warranty covering any defects in materials and workmanship. Retro Manufacturing, LLC (collectively referred to as "the warranter"), at its option, will either (a) repair your unit with new or refurbished parts or (b) replace it with a new or refurbished unit. The warranty period starts from the original purchase date and is valid for the length of time indicated in the chart below.
Need help?
Do you have a question about the RetroAntenna WPA2 and is the answer not in the manual?
Questions and answers