Antenna - Zenith HealthView H20C50DT Installation And Operating Manual, Warranty

Hook Up The Antenna to the TV
Connect an off-air antenna to the HealthView TV
1 Locate the Antenna/Cable jack on the back of the
HealthView TV.
Connect the cable that runs from the wall directly to
2
this jack, according to the diagram to the right.
3
Remove the back of the remote and put in two
AA batteries.
4
Plug in the TV. Do not plug it into a switched outlet.
the HealthView TV is designed to operate on standard
current, 120-volt 60 Hertz AC. Do not attempt to oper-
ate it on DC Current.
5
Go to page 11 to Auto Program the TV.
If you have a 75 ohm RF cable, then you don't need
any adapters.
A 300 to 75 ohm adapter is not included with the
Zenith HealthView TV.
Mini glossary
75 OHM RF CABLE The wire that comes from an off-air antenna or cable service provider. Each end looks like a hex shaped nut with a wire
sticking through the middle, and it screws onto the threaded jack on the back of the TV.
A small device that connects a two-wire 300 ohm antenna to a 75 ohm RF jack. They are usually about an inch long with two screws
300 TO 75 OHM
on one end and a round opening with a wire sticking out on the other end.
ADAPTER
P A G E 6
back of
remote
TV back

Antenna

Flat wire
(300 ohm)
ANTENNA
CABLE
M.P.I.
TV back panel
300/75 ohm
(expanded view)
Adapter
TV back
Antenna
RF coaxial wire
ANTENNA
(75ohm)
TV back panel
(expanded view)
TV
PILLOW SPEAKER
SPKR
PILLOW
SPKR
CABLE
M.P.I.
TV
PILLOW SPEAKER SPKR
PILLOW
SPKR
206-3491-O