Page 1
Kit Installation/Parts ® 313541C DataTrak Kits For providing pump diagnostics and material usage information for spray packages. Conversion Kits 24A575, 24A576, and 24A592 Replacement Parts Kits 24B564, 24B565, and 24B566 See page 2 for model information, including agency approvals. Kit 24A592 Important Safety Instructions Read all warnings and instructions in this manual and in your spray package manual (312797,...
Page 2
DataTrak Conversion Kits DataTrak Conversion Kits Air Valve Part Fits NXT Air Motor Replacement Kit Description Models Required* M04LN0 24A353 DataTrak with Runaway 24A575 Protection Kit M04LT0 ----- M07LN0– M18LN0 24A354 DataTrak with Runaway 24A576 Protection Kit M07LT0– M18LT0 ----- DataTrak with Cycle 24A592 MxxLN0...
Prepare to Install Prepare to Install 4. Use the screw provided to attach the reed switch just behind the air inlet. Remove the muffler, if needed, for easier access. Rotate the air inlet fitting 1. Relieve the pressure. Follow instructions in your as needed so the wrench flat clears the reed switch.
Page 4
1. Enable runaway and set the runaway limit. 2. Configure the DataTrak as needed. Be sure to dis- Graco recommends setting runaway to 60. able runaway monitoring. 2. Run the air motor at a speed slower than the run- away limit.
Page 5
Parts Parts Models 24A575 and 24A576 Model 24A592 ti13531a ti13532a Ref. Ref. Part No. Description Part No. Description 24B563 DATATRAK module (includes 24B563 DATATRAK module (Includes Part 4) Part 4) SOLENOID/REED SWITCH, kit 24B564 REED SWITCH, assembly (includes Parts 2a-2d) (includes Parts 3a and 3b) 24B565 For Model 24A575...
With the exception of any special, extended, or limited warranty published by Graco, Graco will, for a period of twelve months from the date of sale, repair or replace any part of the equipment determined by Graco to be defective.