Connections; Connecting To A Tv - Zenith DVB312 Installation And Operating Manual

Connections

ips
Depending on your TV and other equipment you wish
to connect, there are various ways you could connect
the player. Use only one of the connections
described below.
Please refer to the manuals of your TV, VCR, Stereo
System or other devices as necessary to make the
best connections.
For better sound reproduction, connect the player's
AUDIO OUT jacks to the audio in jacks of your
amplifier, receiver, stereo or audio/video equipment.
See "Optional Equipment Connections" on page 10.
Caution
– Make sure the DVD Player is connected directly to the
TV. Tune the TV to the correct video input channel.
– Do not connect the DVD Player's AUDIO OUT jack to
the phono in jack (record deck) of your audio system.
– Do not connect your DVD Player via your VCR. The
DVD image could be distorted by the copy protection
system.

Connecting to a TV

Make one of the following connections, depending on
the capabilities of your existing equipment.
Video connection
1 1
Connect the VIDEO OUT jack on the DVD Player to
the video in jack on the TV using the supplied video
cable (V).
2 2
Connect the DVD Player's Left and Right AUDIO
OUT jacks to the audio left/right in jacks on the TV
using the supplied audio cables (A).
S-Video connection
1 1
Connect the S-VIDEO OUT jack on the DVD Player
to the S-Video in jack on the TV using the supplied
S-Video cable (S).
2 2
Connect the DVD Player's Left and Right AUDIO
OUT jacks to the audio left/right in jacks on the TV
using the supplied audio cables (A).
Component Video (Color Stream
1 1
Connect the COMPONENT VIDEO OUT/
PROGRESSIVE SCAN jacks on the DVD Player to
the corresponding in jacks on the TV with optional Y
Pb Pr cables (C).
2 2
Connect the DVD Player's Left and Right AUDIO
OUT jacks to the audio left/right in jacks on the TV
using the supplied audio cables (A).
10
Progressive Scan (ColorStream
If your television is high-definition or "digital ready",
television, you may take advantage of the DVD
Player's progressive scan output for the highest video
resolution possible.
If your TV does not accept the Progressive Scan for-
mat, the picture will appear scrambled if you use the
DVD's Progressive Scan output.
1 1
Connect the COMPONENT VIDEO OUT/
PROGRESSIVE SCAN jacks on the DVD Player to
the corresponding in jacks on the TV using an
optional Y Pb Pr cable (C).
2 2
Connect the DVD Player's Left and Right AUDIO
OUT jacks to the audio left/right in jacks on the TV
using the supplied audio cables (A).
otes
– Set the Progressive to "On" on the setup menu for
progressive signal, see page 13.
– Progressive scan does not work with the analog video
connections (yellow VIDEO OUT jack).
TV Connections Panel
® ) connection
DVD
Connections
Panel
® pro) connection
S-VIDEO
COMPONENT VIDEO /
AUDIO INPUT
PROGRESSIVE SCAN INPUT INPUT
Pr Pb Y
R
C S A
VIDEO
INPUT
L
V