ONE POINT REPAIR GUIDE
When you turn on your set, it will display "HELLO" or "WAIT" on front panel, and it
will not boot-up normally.
3-5. COIL USING IN DCDC IC(L201, L206)
3-5-1. Solution
Re-soldering the Coil.
3-5-2. How to troubleshoot (Countermeasure)
1) Please check 1.2 V of IC201, 1.5V of IC202.
2) If there is problem of input voltage, check the input voltage 5.3 VA.
3) If there is no problem, check the L201, L206 like below picture.
3-5-3. Service hint (Any picture / Remark)
L206
Bad soldering
< MAIN board top view >
3-74