3. NO BOOTING WHEN YOU TURN THE UNIT ON, "HELLO" OR "WAIT" ON
FRONT PANEL
When you turn on your set, it will display "HELLO" or "WAIT" on front panel,
and it will not boot-up normally.
3-1. IC209, IC302
3-1-1. Solution
Replace IC209 or IC302 on main board.
3-1-2. How to troubleshoot (Countermeasure)
1) Please check VCC MICOM_3.3 VA of IC302 pin48.
If it doesn't work, check 3.3 VA from IC209 pin1.
If it doesn't work, check 5.3 VA input voltage from IC209 pin2.
If 5.3 VA is working, change the IC209.
2) If 3.3 VA is working, check the MPEG reset of micom pin8, power control pin 9, 10, 11.
If it doesn't work, change the IC302.
3-1-3. Service hint (Any picture / Remark)
There was a micom pin not good soldering because micom pin is not flat.
So it is needed to check the Micom soldering state.
< MAIN board bottom view >
ONE POINT REPAIR GUIDE
3-70
MICOM
< MAIN board top view >
3.3VA LDO