Table of Contents
Advertisement
ADJUSTMENTS CONTD_
Additional range to the cutting height can be achieved by
repositioning the cutter deck in relationship to the engine
deck (This adjustment can also effect the pitch of the deck).
There are 3 positions (see figure 6), suggested mounting is
the middle holes. For cutting lower, mount the deck in the
top holes. To cut higher, mountthe deck in the bottom holes.
Remember to check the cutter deck belt alignment. Shim¬
ming or attaching the idler mounting bracket from under¬
neath may be necessary to maintain belt life'.
Caster spacers also can be repositioned to change cutting
heights and to change the pitch of the deck (see figure 11).
Quick Pin
Caster Spacers 1/2"
Caster Support
Caster Spacers 1/2"
Figure 11
LUBRICATION & MAINTENANCE
BREAK-IN
40 HOURS (WEEKLY)
100 HOURS (BIWEEKLY)
.. 200 HOURS (MONTHLY)
_PROCEDURE_
Check all hardware for proper tightness
Change engine oil and filter at 5 hours
Check engine cut
Remove debris from under belt cover
Clean air filter_
Check tire pressure
Change engine oil
Replaceairfilter-quali
Grease Idler bracket IH & RH
(jrease brake lever pivot
X
Grease transmission couplers
X
Check all hardware for proper tightness
COMMENTS
; Do not over fill
i-t?1 ; : : : ; v'
:
More often if needed
More often if needed
+ US lithium MP White Grease 2125
More often if needed_
Add or adjust as required
See engine mfg. information
More often if needed
Chassis grease
Chassis grease
+ Grease spindle until grease comes out the relief valve
8
Advertisement
Table of Contents
