Peavey KB 100 Operating Manual page 4

Hide thumbs Also See for KB 100:

Available languages

POWER SWITCH (14)

Depress the switch to the "On" position. The red pilot light (LED) will illuminate indicating power is being

supplied to the unit.

„oo.

Ef q bo =

LINE CORD

(120V PRODUCTS

ONLY) (15)

HEADPHONE

OUT (16)

This stereo jack allows the signal to flow to both sides of any stereo headset. When headphones are connected

to the amplifier, the internal speaker is automatically turned off.

NOTE: The headphone system will not work with headsets equipped with a mono phone plug.

PREAMP

OUT/POWER

AMP IN (17)

NOTE: The preamp output level is approximately 1 volt RMS and is of relatively low impedance (600 ohms).

Any effects device used in this effects loop must be capable of receiving 1 volt input and providing 1 volt

output in order to properly drive the power amp. The Power Amp Input has an internal switch which discon-

nects the internal preamp.

REMOTE

SWITCH

(18)

For connection of a footswitch (optional) and is used to activate/defeat reverb.

ola

Gei?

PACK MOUNTED EFFECTS

PATCH DIAGRAM