Sony DAV-X1 Operating Instructions Manual page 2

To prevent fire or shock hazard, do not
expose the unit to rain or moisture,
Caution -The use of optical instruments
with this product will increase eye
hazard.
For the customers in the U.S.A
mqmmmm_m
This symbol is intended to ale_t the user to
the presence of tminsulated "dangerous
voltage" witifin tile pro&ict's enclosme that
may be of sufficient magnitude to constitute a risk of
electric shock to persons
This symbol is intended to alert the user to
tile presence of important operating and
maintenance (sac/icing) instructions in the
literature accompanying ti_e appliance
Owner's Record
The model anti serial nmnbers me located at the bottom
of ti_e refit. Record the serial number in the space
provided below. Refe_ to them wheneve_ you call upon
your Sony dealer regarding tiffs product.
Model No DAV-XI
Serial No.
WARNING
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant to
Pa_t 15 of the FCC Rules These limits are designed to
provide reasonable protection against hannful
interference in a residential installation. This
equipment generates, uses, and can radiate radio
fiequency energy and, if not installed and used in
accordance with the instructions, may canse harlnfifl
interference to radio comammications. However, there
is no guarantee that interference will not occm in a
particular installation. If tiffs equipment does cause
hannfifl interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to t_y to correct the
interference by one or more of the following measures:
Reorient or relocate ti_e receiving antenna (aerial).
Increase the separation between the equipment and
recei;_er
Connect the equipment into an outlet on a circuit
different fiom that to which the receiver is
connected.
Consult the deala or an experienced radio/TV
technician tbr help
CAUTION
You are cautioned timt any changes or modifications
not expressly approved in this manual could void your
anthority to operate this equipment.
Note to CATV system installer:
This _eminde_ is provided to call ti_e CATV system
installer's attention to Alticle 820-40 of the NEC that
provides guidelines for proper grmmding and, in
partictflar, specifies that the cable ground shall be
connected to the grounding system of the building, as
close to the point of cable entry as practical.
For the customers in Canada
CAUTION
TO PREVENT ELECTRIC SHOCK MATCH WIDE
BLADE OF PLUG TO WIDE SLOT, FULLY
INSERT.
Precautions
Safety
• If anything falls imo the cabinet, tmplug the trait and
have it checked by qualified personnel before
opaating it any fluther
• The refit is not disconnected from the AC power
source (mains) as long as it is connected to ti_e wall
outlet (mains), even if the unit itself has been turned
off..
• Unph_g the unit flora the wall outlet (mains) if you do
not intend to use it for an extended period of fime To
disconnect the cord, pull it out by the plug, neve_ by
the cord.
Installing
• Allow adequate air circulation to prevent internal
heat buildup.
• Do not place the unit on smfaces (rugs, blankets, etc.)
or near materials (curtains, draperies) that may block
the ventilation slots
• Do not install the trait near heat somces such as
radiators, o; air ducts, or in a place subject to direct
sunlight, excessive dust, mechanical vibration, or
shock
• Do not install the unit in an inclined
position. It is
designed to be opaated in a horizontal position only.
2us