Marquette B Series Operating Instructions Manual
  1. Manuals
  2. Brands
  3. Marquette Manuals
  4. Welding System
  5. B Series
  6. Operating instructions manual

Marquette B Series Operating Instructions Manual

Hide thumbs Also See for B Series:
1
2
3
4
5
6
7
8
9

Advertisement

Table of Contents

OPERATING INSTRUCTIONS
MANUEL D'INSTRUCTIONS
MANUAL DE INSTRUCCIONES
Plasma Cutter Service
8600 NE Underground Drive, Pillar 248
866-236-0044
Kansas City, MO 64161
(800) 328-2921
IMPORTANT OPERATING INSTRUCTIONS
SAVE THESE INSTRUCTIONS
FOR MODEL:
SERIES B
811-680-000
2/03
M12157
3.330.866

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the B Series and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Related Manuals for Marquette B Series

Summary of Contents for Marquette B Series

  • Page 1 OPERATING INSTRUCTIONS FOR MODEL: SERIES B MANUEL D’INSTRUCTIONS M12157 MANUAL DE INSTRUCCIONES IMPORTANT OPERATING INSTRUCTIONS SAVE THESE INSTRUCTIONS 3.330.866 Plasma Cutter Service 811-680-000 8600 NE Underground Drive, Pillar 248 2/03 866-236-0044 Kansas City, MO 64161 (800) 328-2921...
  • Page 2 OPEN OPEN mm 1,5 15° max.

  • Page 3: Safety Devices

    PLASMA CUTTER INSTRUCTION MANUAL Read this entire manual carefully before using this • Do not use the unit with the cover removed. This is dan- unit. Failure to respect the rules described herein shall gerous both for the user and for any bystanders in the exempt the manufacturer from any liability.

  • Page 4: Installation

    Do not attempt to drill holes or start cutting from the center of a 6 INSTALLATION piece unless your material is thicker than 1/16" (2mm). When cutting this way, the torch should be tilted and then slowly The unit must be installed by qualified personnel. All fit- tings must be in conformity with existing rules, and in full straightened to prevent molten metal from being spread onto compliance with safety regulations.
  • Page 5 10 PRACTICAL RECOMMENDATIONS 14 BASIC SAFETY PRECAUTIONS WARNING: DISCONNECT POWER SOURCE BEFORE • If the system air contains excessive humidity or oil, you will need to use a drying filter to avoid oxidation and wear DISASSEMBLY OF THE TORCH. of consumable parts, torch damage, and/or reduced ELECTRIC SHOCK speed and quality of cutting.
  • Page 6 • Clean the work piece so it is free of any solvents or halo- • Do not put the cylinder in electrical contact with the plas- gen degreasers that may create toxic gases when cutting. ma arc. Some chlorine solvents may decompose with radiation •...
  • Page 8 When ordering spare parts, always state the following: El pedido de las piezas de repuesto debe indicar siem- La demande de piéces de rechange doit toujours indi- machine part number, machine serial number, item posi- pre el número de articulo, la posición, la cantidad y la quer le numéro de l’article, la position, la quantité...
  • Page 9 118-025, 82051, M12157, (37150) M12157, 118-025 Lincoln Lincoln Item Customer # Description Item Customer # Description Stock # Stock # 312-512-666 250728 Handle 210-358-666 251192 Coupling Coil for Reed Switch 411-109-026 250907 Left Side Panel 411-125-666 250885 Reed Switch 3190275 Contactor 216-108-666 246224...

This manual is also suitable for:

M12157

Table of Contents