Advertisement
Note: Whilst in the Dual Clutch setting mode the RPM LEDs will not respond to the
game/SDK.
2. Press the button you want to set as the
dual clutch button. The only valid buttons
for this are the left stick button (LSB) and
right stick button (RSB). The RPM LEDs will
flash red to show that you're in clutch
position setting mode.
3. While in your chosen simulation or game
with the car still on a track, fully depress
the clutch and gas pedals. Engage first
gear and keep pressing the minus button
down until the car begins to move
in-game. You can adjust the precise bite
point of the clutch by using the plus and
minus buttons until you are happy with the
setting.
4. At this point you may test the dual clutch
without leaving the setting mode. It is
recommended you attempt a race start,
stop the car and adjust the bite point and
then try again until you are satisfied with
the performance of the dual clutch.
5. Press the Select button in the middle of the
dial on the wheel to exit dual clutch setting mode. The RPM LEDs will flash in a
sequence from green to blue to show that the setting is saved. The RPM LEDs will then
go out and begin responding again to RPM output from supported games.
Resetting the dual clutch system
Press and hold the left gear shift, right gear shift, and X button for two seconds.
The RPM LEDs will all flash four times and then extinguish to indicate that the Dual Clutch
system has been reset.
The button assigned to the Dual Clutch system (LSB or RSB) will revert to its normal function.
G923 TRUEFORCE Racing Wheel for Xbox and PC FAQs
11
Advertisement
