Kenwood TS-130SE Instruction Manual page 16

(1) Antenna Location Selection
(2) Antenna Matching
© Matching Circuit Examples
H OUTPUT
INPUT OUT PUT INPUT:
L
-O oO
oO
Fig. 4-12 Matching Circuits
(3) Bonding
The component parts of motor vehicles, such as the engine,
transmission, muffler system, accelerator, etc., are coupled
to one another at DC and low frequencies, but are isolated at
high frequencies. By connecting these parts using heavy,
braided ground straps, ignition noise can be reduced. This
connection is called "bonding".
(4) Use Ignition Suppressor Cable or Suppressor Spark
Plugs
Noise can be reduced by using spark plugs with internal
resistors, or resistive suppressor ignition cable.
(5) Battery Power Connection
It is recommended that battery power be supplied directly to
the TS-130SE from the battery terminals.
CAUTION:
Disconnect the TS-130SE before jump-starting or before
charging the battery.
(6) Battery Capacity
battery.
maintenance:
16
4.9.1. Power
4.9.2. ANTENNA
Fig. 4-13 Rotary Beam Antenna
NOTE:
Protect your equipment
— use a lightning arrestor.