Advertisement
mi TO REMOVE CHASSIS
1. Open the battery cover.
2. Remove
two (2) cabinet cover screws,
nos. 1 & 2, as il-
lustrated in fig. 1.
.
3. Open the cabinet cover.
4. Pull out three (3) connecting sockets.
5. Remove two (2) chassis screws, nos. 1 & 2, as illustrated
in fig. 2.
.
|
6. To
remove
chassis "completely,
unsolder
lead
wire
to
speaker terminals.
7. To reassemble, reverse the above procedure and read the'
following notes.
2. Turn tuning capacitor to fully minimum.
3. Insert the shaft of tuning capacitor in the hole of dial drum.
~ Screw No.1 (CHa) -
Screw No.2 (CHa)
M@ DIAL CORD
INSTALLATION
GUIDE
1. Remove chassis from cabinet.
(Refer to chassis removal instruction.)
Remove tuning knob as illustrated in fig. 5.
Dial cord tength is 80 cm (31%'').
Turn dial drum to fulley clockwise.
Arrows (1~8) indicate correct order and direction of dial
cord installation as illustrated in fig. 4.
6. Cement dial cord ends.
O ek
Mi TO REMOVE
DIAL
POINTER
1. Pull out the cover as illustrated in fig. 6.
2. Remove dial pointer.
M@ TO MOUNT
DIAL POINTER
1. Set arrow
mark of dial drum to arrow
mark of cabinet as
illustrated in fig. 3.
2. Set dial pointer to start point (0) of dial scale.
3. Attach dial cord to dial pointer.
Arrow Mark
Tuning Knob
(CA\)
Fig. 3
pufey
|
Pulley
(CAi
Tuning Shaft
/
RF-516
Advertisement
