Yamaha VL-1m Owner's Manual page 32

Getting Started
7.
Return to the Play Mode, Eject the Disk, & Select a Voice
When the "Completed!" display appears, press the P button to return to the
play mode, then press the eject button below the disk drive slot to eject the disk. Store
the disk in a safe place. You must now select a voice in order for the loaded data to be
properly activated — see the following section.
About the VL1-m Data Disk
The floppy disk supplied with the VL1-m contains the following files:
001:NOBREATH:ALL
A complete set of 128 voices and system data in which the voices are
programmed to be played without a breath controller. This is the voice set
which is in the VL1-m memory when the unit is initially shipped. The
voices can be controlled via keyboard initial and after-touch, and via a
modulation wheel (MIDI control change number 001).
002:FULLCTRL:ALL
A complete set of 128 voices and system data in which the voices are
programmed to allow maximum controller variation. A breath controller
(MIDI control change number 002), foot controller (MIDI control change
number 004), and one other controller assigned to MIDI control change
number 013 are required for voice control.
003:STANDARD:ALL
A complete set of 128 voices and system data in which the voices are
programmed to be used with a breath controller (MIDI control change
number 002), but MIDI control change number 013 is not assigned. This
voice set is also suitable for use with a MIDI Wind Controller such as the
Yamaha WX11.
004:WXSELECT:ALL
A set of 32 voices and system data in which the voices are "fine tuned"
for optimum sound and control variation when played via the Yamaha
WX11 MIDI Wind Controller.
005:EXAMPLE:ALL
Some example voices in which the controller settings are emphasized.
Setting Up
32