Advertisement
Quick Links
Advertisement
Related Manuals for FIRNEWST D-THO-5524SS
Summary of Contents for FIRNEWST D-THO-5524SS
- Page 1 ELECTRIC SIT-STAND DESK Instruction Manual D-THO-5524SS D-THO-6324SS...
- Page 2 Beam Left Leg Right Leg Drive Rod Side Plate Leg Base Board Board Board Square Board Desk Connection Hook Rectangular Board Power Supply Hand Controller Wire Plate Drawer Desk Connection Plate Cable Hole Cover Wooden Pin Cable Clip Silicone Sheet Hidden Screws Board Screws...
- Page 3 Screws Screws Screws Screws Screws 2.5mm Screws Wrench Wrench Screwdriver is required during the installation please prepare it in advance. Step 1 Align the holes of Left Leg (2) and Drive Rod (4), using Wrench (M-G) to secure both with Screw (M-A).
- Page 4 Step 2 Insert Drive Rod (4) into the hole of Right Leg (3). If it cannot be inserted tilt Right Leg (3) slightly until they’re matched. Step 3 As shown, use Wrench (M-H) , install Beam (1) to the Legs (2&3) with Screws (M-B)*6.
- Page 5 Step 4 Step 5...
- Page 6 Step 6...
- Page 7 Step 7 Step 8...
- Page 8 Step 9 Step 10...
- Page 9 Step 11 Step 12...
- Page 10 Step 13 Step 14...
- Page 11 Step 15 Step 16...
- Page 12 Step 17 Step 18...
- Page 13 Step 19 Step 20...
- Page 15 Step 21...
-
Page 16: Using The Controller
Using the Controller Raise the Desk Press the button to raise the desk continuously until it reaches the highest position or the button is released. Lower the Desk Press the button to lower the desk continuously until it reaches the lowest position or the button is released. -
Page 17: Child Lock
Settings Reset Press and hold the button until 'rst' is displayed. Continue holding until the desk goes down to its lowest level and comes back up slightly. Release the button, and reset is complete. If the button is released during the reset procedure, reset will stop. The desk won't work until reset is done correctly. - Page 18 Protection Mode Error Codes Standby Overvoltage Protection: Standby voltage too high. and the controller, and power on again. If error code persists, please contact technical support. Power Supply Overvoltage Protection: Input voltage too high. check the connection between power and the controller, and power on again.
- Page 19 Overloading Protection: Max load exceeded. Error code will the desk and confirm there is no mechanical damage before trying again. connection between the motor and the controller, and power back on again. Then follow the reset instructions. If error code persists, please contact technical support. Sensor Malfunction Warning: Motor sensor can’t be the motor and the controller, and power back on again.
Need help?
Do you have a question about the D-THO-5524SS and is the answer not in the manual?
Questions and answers