Advertisement
{How to install Tray 1 for Twin-tray CD player]
When installing Tray 1, first remove the front panel to
Slide angle U unit
make the work easier.
1.
Put the slide angle U unit to the very front (the po-
sition when Tray 1 is completely open).
Put the slider in the very front as shown in Figure
11,
With Tray 1 at a slight angle as indicated by the
dotted lines in Figure 12, insert Tray 1 until the
slider and Tray 1 screw holes are lined up, being
careful that the slider does not move to the rear.
€ section expanded
While moving Tray 1 to the right (the guide side),
lower it. Support the slider from below by hand.
Setting the catch section A of Tray 1 so that it
catches on the Slide angle U unit as shown in Fig-
ure 13, insert the protruding section B of Tray 1
into the hole of the slider. At the same time, mesh
the synchronization gear and the gear section of
Tray 1.
After double checking that the screw hole of the
slider is positioned at the center of the screw hole
of Tray 1 as shown in Figure 14, fasten with
Moveto
Slide angle U unit
Screws C1 and C2 in that order.
Tray 1 is completely open, the position relations
are as shown in the E section expanded diagram
le eee
72
If they are not, repeat the installation of Tray 1
Hi
Slide angle U unit
|
aweat
is SS
CLS SS es
(oe
from the start.
batettret
SAABAA:
Synchronization gear
: The tip of the guide base and the tray
marker are lined up. When Tray 1 1s m-
stalled poorly, they are about 2 mm apart
Figure 12
COU.
Slider
Example of poor installation
Example of best installation
The protrusion section B of Tray 1
is not in the slider hole.
Figure 14
19
Advertisement
