Table of Contents
Advertisement
Siena Twist+
All Stage 360° Car Seat
Instruction Manual
NOTICE
This is an "i-Size" Child Restraint System.
i-Size ISOFIX car seat suitable 40cm–135cm.
Approved to Regulation No.129, for use in, "i-Size compatible" vehicle
seating positions as indicated by vehicle manufacturers in the vehicle
users' manual.
If in doubt, contact hello@amanababy.com.
DO NOT USE REARWARD FACING ECRS IN SEATING POSITIONS WHERE
THERE IS AN ACTIVE FRONTAL AIRBAG INSTALLED. UNIVERSAL Vehicle
ISOFIX Child Restraint Systems. IMPORTANT - DO NOT USE FORWARD
FACING BEFORE THE CHILD'S AGE EXCEEDS 15 months (Refer to
instructions).
Advertisement
Table of Contents
Related Manuals for Amana Siena Twist+
Summary of Contents for Amana Siena Twist+
- Page 1 Siena Twist+ All Stage 360° Car Seat Instruction Manual NOTICE This is an “i-Size” Child Restraint System. i-Size ISOFIX car seat suitable 40cm–135cm. Approved to Regulation No.129, for use in, “i-Size compatible” vehicle seating positions as indicated by vehicle manufacturers in the vehicle users’...
- Page 2 Stature: Child height 40–135cm Weight: 0–36kg Suitable age: Birth – approx. 12 Years Rearward facing 40–105cm: ISOFIX + Support leg + harness Forward facing 76–105cm: ISOFlX + Support leg + harness Forward facing 100–135cm: ISOFIX attachments + adult safety-belt or adult safety- belt only Please carefully read this manual and follow each step to ensure a comfortable travel and best protection for your child.
-
Page 3: Table Of Contents
Contents 1. Warning ............3 2. -
Page 4: Warning
1. Warning To ensure that your child is protected to a greater degree, please read the following instructions carefully: 1. Do not put the child on seats with activated airbag under any circumstances. 2. Please read the relevant ISOFIX interface instructions in the car user manual provided by the car manufacturer before installing this seat. - Page 5 12. Luggage in the car or sharp and hard objects should be tied well. Loose objects may hurt others in the event of an accident. 13. When the child car seat is not in use, it is recommended that the seat always be secured to avoid being thrown out in the event of an accident.
-
Page 6: Safety Instructions
2. Safety Instructions • If you are driving for a long time, please stay appropriately on the way, otherwise the child will get tired easily. Please keep the child in the child seat when the car is moving. • If the child unfastened the safety belt of the child car seat, the car should be parked in a safe place immediately, and the safety belt should be re-fastened before starting the car. -
Page 7: Installation Mode Selection
2.1 Installation Mode Selection Installation Stature Mode Fixed Mode Position Diagram ISOFIX+ 0–4 40–105cm Baby Mode Position 4 Support Leg Years Old Toddler ISOFIX+ 1–4 76–105cm Position 1 – 3 Mode Support Leg Years Old School ISOFIX+ 3–12 100–135cm Children Adult Safety Position 1 Years Old... -
Page 8: Structure
3. Structure 1. Headrest adjustment handle 9. Strap adjusting button 2. Headrest 10. Adjusting strap 3. Fabric cover 11. Recline handle 4. Shoulder strap (shoulder safety strap) 12. 360° rotation button 5. Insert cushion 13. Support leg adjusting button 6. Shoulder pad 14. - Page 9 17. Shoulder strap guide 22. ISOFIX interface 18. Belt guide 23. ISOFIX unlock button 19. Left and right energy 24. ISOFIX second-lock button absorption side protection 25. FIX status red and green windows 20. Backrest shell 26. Support leg release button 21.
-
Page 10: Use In The Vehicle
4. Use In The Vehicle 4.1 Install In The Car Correct Position TIMES-CI The child restraint system complies with the ECE UN R129/03 standard. For use in, the compatible child car seat seating on the vehicle as indicated by vehicle manufacturers in the vehicle users’ manual. It will fit most, but not all vehicles. Please read the applicable car list to check that your vehicle is listed on it. - Page 11 When 40–105cm, the ECRS is restrained by ISOFIX+ Support leg, not by Adult safety- belt. WARNING! Never install the child seat on the side seat at right angles to the EXCLAMAT direction of the car. The child seat is also not suitable for rear-facing seat in the car, such as minivans or minibuses.
- Page 12 IMPORTANT! EXCLAMAT Do not use forward facing before the child’s age exceeds 15 months it must not be installed and used forward (according to the child safety seat industry consensus, we recommend that you use the backward restraint system to fit your child and body. Please try to extend the time for your child’s backward use. Please refer to the instructions for use).
-
Page 13: Adjusting The Child Seat
4.2 Adjusting The Child Seat The child seat has a 360° rotation function, and the backrest can be adjusted in 3 positions at any angle to meet the needs of different comfort levels. Pull up the s recline handle, at the same time push or pull the seat to the required position. -
Page 14: Adjusting The Harness
4.3 Adjusting The Harness CAUTION! Please ensure no toys or other objects in the child safety seat. Loosen EXCLAMAT the shoulder straps: press the o central adjusting button, and simultaneously pull the r two shoulder straps outwards (only pull the shoulder straps, not the y shoulder pads) to separate the shoulder straps from left and right, and put the baby in. -
Page 15: Adjusting The Headrest
4.3 Adjusting The Headrest Tighten the shoulder strap: Pull a adjusting strap with one hand until the shoulder strap is flat against the child’s body. CAUTION! Grasp the r shoulder strap with one EXCLAMAT hand (see figure with index finger and middle finger) and then slowly pull a adjusting strap with one hand until the shoulder strap and fingers are flat against the child’s body, stop pulling the a adjusting strap, the strength of pulling shoulder straps should be moderate. -
Page 16: Installation
5. Installation 5.1 ISOFIX Before Installation Before installation, the user should read the instructions on ISOFIX anchor points in the ISOFIX car manufacturer’s manual. Please choose a suitable installation seat in the car, take out the ISOFIX sleeve from the bottom of the base shell and install it to the iron rod connected with the car (If there is an ISOFIX sleeve in the car itself, no installation is... -
Page 17: Isofix Unlock
5.3 ISOFIX Unlock • Press the ISOFIX unlock button and the secondary lock button at the same time until a “click” sound is heard and the ISOFIX status window displays red, indicating unlock is done. This method applies for both sides. •... -
Page 18: Fold The Support Leg
5.6 Fold The Support Leg Adjust the support leg to the ‘click’ shortest, press the support leg movement unlock button then firmly push the support leg inward, fold it into the groove of the base and press it to a state that it won’t fall out naturally. Note that the support leg cannot be suspended in the air or supported by other EXCLAMAT objects. -
Page 19: Installation For Rearward Facing 40-105Cm
5.8 Installation For Rearward Facing 40–105cm: CAUTION! In order to provide your child with ideal protection and safety, the EXCLAMAT height of the headrest must be adjusted to a suitable position. The height of the headrest can be adjusted by one key stop. The headrest must be adjusted to leave a gap no more than two fingers between the child’s shoulders. -
Page 20: Installation For Rearward Facing 76-105Cm
5.9 Installation For Rearward Facing 76–105cm: For 76–105cm The child safety seat can be installed forward. In order to provide comprehensive protection for children, we recommend using the child safety seat in the rearward position as long as possible. If the child’s leg space is insufficient, the forward installation can be used. To learn more about how to protect your child, please refer to the chapter “Adjusting seat belt”. - Page 21 WARNING! Do not use any front guard unless specified or specified in the EXCLAMAT safety seat manual. The car seat belt must be used according to the instructions. Supporting leg is not allowed when 100–135cm. Adjust the support leg to the ‘click’ shortest, press the support leg movement unlock button, then firmly push the support leg inward, fold it into the groove of the base and press it to a state that it won’t fall...
- Page 22 Installation 1: ISOFIX Attachments + Adult Safety Belt CAUTION! When 100–135cm the supporting leg must be retracted and folded into EXCLAMAT the base and the backrest must be adjusted to the upright position. ‘click’ *Consult the manufacturer or retailer of the child restraint system if you have any questions about the installation procedure...
-
Page 23: Remove The Seat From The Car
Installation 2: Adult Safety Belt Only • The five-point safety belt system concealment method is shown on page 23. • When 100–135cm (see page 24), it is not necessary to use the FIX interface and the support leg folded. After installation, please check: pull the extra car seat belt back into the retractor to ensure that the seat belt does not twist and turn over and the seat does not shake. -
Page 24: Remove Fabric Cover
5.12 Remove Fabric Cover 1. Open the buckle, and remove the shoulder pad, protect pad, cushion and baby cushion from position 1 according to the serial number as shown in the figure. 2. Turn the headrest against the cloth cover, and remove the headrest cover along the side of the headrest. 3. Pull out a bit of the backrest cloth cover, pull out the backrest cloth cover along the gap between the backrest and the outer cover plate, and then pull out the cloth cover on the four sides of the backrest. -
Page 25: User Instructions
6. User Instructions Thank you for purchasing Siena Twist+ All Stage 360° Car Seat! The illustrations used in this manual are to illustrate the operation method and product structure of the product. In case of a small difference between the real product and the drawing, the real product shall prevail. - Page 26 • When cleaning the fabric cover, please gently scrub with soap and warm water. Please do not use any detergent, solvent or strong soap. • Do not remove, move or change any structure or part of the fabric cover or seat belt system of the child safety seat;...
- Page 27 Instruction Manual Siena Twist+ All Stage 360° Car Seat...
- Page 28 hello@amanababy.com Imported by Millsons of London Ltd. EC1V 2NX Made in China...
Need help?
Do you have a question about the Siena Twist+ and is the answer not in the manual?
Questions and answers
S should the support leg be moveable when placing in car until it is lengthened and t the floor of car keeps it in place
Yes, the support leg of the Amana Siena Twist+ should be movable when placing it in a car until it is lengthened to the floor. It must be adjusted until it stably contacts the ground and the force indicator shows green, indicating it is locked in place.
This answer is automatically generated