Yamaha K-1020 Owner's Manual page 7

Insert plugs firmly, taking care not to mix up L and R.
LINE OUT/PLAY (Playback output)
LINE IN/REC (Rec input) Remote Control Terminal
ПІ
Dolby nose nedocbon and recaro
chose From Dolby а.а
HX Protesconal сучи сл Dy Ba
Миш douen syowol ome tracted
Lec C ation.
MAooufeccuned cocer dbx' kcense .
"Under Leanne cf Stoor S.A, Gouriselp, Belgun
> па > Ф
© | Ф
REC OUT (Rec output)
TAPE PB (Playback input) | ]
mt RPP LTA
TAPE
TAPE PB REC OUT
Connect to an AC
power outlet.
Or to unswitched
AC OUTLET of amplifier.
Integrated amplifier,
preamplifier or receiver.
The K-1020 is equipped with a
connector terminal for remote control.
Therefore, remote operation is possible
by using the optional remote control
unit (RS-20).
Make sure that the plugs are
inserted firmly. Ħ insertion
is incomplete, noise or hum
may result.
Remote control unit RS-20
Accessories
EIA rack mount adaptors are available
for the K-1020, sold separately.
Be sure to connect the left (L) and right (R) channels consistently.
= HOW TO LOAD AND UNLOAD CASSETTES
ti Open the cassette compartment cover by pressing the Eject
button.
. The side of the tape you wish to record or playback should be
facing the front. Insert the cassette with the exposed tape edge
down, and fit it into the chamber.
. Push the cassette cover closed until you hear an audible click.
. To unload the cassette, press the Eject button. |
Remember to keep the cassette compartment cover closed
when not using the deck to protect the heads and inner
assembly fram exposure to dust and other foreign elements.
The exposed edge of the tape should be facing down when
inserted into the cassette compartment for either playback or
recording.
Tape exposed
side
а Automatic Tape Slack Tensioning Mechanism
When a tape is loaded while the power is on,
tape slack tensioning operation will begin as soon as
the tape is loaded. This is a special feature that in-
sures that the dual capstan tape drive mechanism
operates to its full potential. This automatic tensioning
mechanism will also operate when the power is turned
on after a tape has been loaded. However, 'if the tape
has excessive slack, the tape slack tensioning
mechanism may not be sufficient to take up all of the
slack. Therefore, before loading a tape, be sure to
take up as much of the tape slack as possible, by
turning a pencil inside the cassette spool.