Chapter 2: Configurations And Features - Dell VxRail VD-4520c Manual

The VxRail VD-4520c is a 2U half-width, single processor compute sled that supports:
● One Third Generation Intel Xeon D Scalable processor with up to 16 cores
● Four DDR4 DIMM slots
● Up to 4 x M.2 NVMe SSDs on PCIe Add-in card and up to 4 x M.2 NVMe SSDs on M.2 riser module.
Do not install GPUs, network cards, or other PCIe devices on your system that are not validated and tested by Dell
Technologies.
CAUTION: Damage caused by an unauthorized or invalid hardware installation will null and void the warranty.
The following figure and table describes the components in the front view of the sled:
Item
1
2
3
4
5
6
7
8
9
10
Configurations and features
Description
PCIe expansion card slot 1 on riser 1C
Network I/O ports that can be shared with iDRAC
PCIe expansion card slot 2 on riser 1C
Serial port
USB 9-pin 3.0 compliant port
iDRAC9 RJ-45 dedicated port
See the Integrated Dell Remote Access Controller User's
Mini-DisplayPort
Sled handle
System ID button is available on the front and back. Press System ID to identify a system in the
rack, reset iDRAC, and access BIOS using the step-through mode. When pressed, the System ID
LED in the back panel blinks until the front or rear button is pressed again. Press the System ID
to switch between on and off.
If the server stops responding during POST, press and hold System ID for more than five
seconds to enter the BIOS progress mode.
To reset the iDRAC (if not disabled on the iDRAC setup page by pressing F2 during system boot),
press and hold the System ID button for more than 15 seconds.
Sled power button
Guide.
Configurations and features
2
9