Carrier 326058-755 Installation Instructions

326058—755 through —758
Two-—Speed Inducer Assembly Kit
Installation Instructions
NOTE: Read the entire instruction manual before starting the
installation.
SAFETY CONSIDERATIONS
Improper _ installation, adjustment, alteration, — service,
maintenance, or use can cause explosion, fire, electrical shock, or
other conditions which may cause death, personal injury, or
property damage. Consult a qualified installer, service agency, or
your distributor or branch for information or assistance. The
qualified installer or agency must use factory-authorized kits or
accessories when modifying this product. Refer to the individual
instructions packaged with the kits or accessories when installing.
Follow ail safety codes. Wear safety glasses, protective clothing,
and work gloves. Have a fire extinguisher available. Read these
instructions thoroughly and follow all warnings or cautions
include in literature and attached to the unit. Consult local
building codes, the current editions of the National Fuel Gas
Code (NFGC) NFPA 54/ANSI Z223.1 and the National
Electrical Code (NEC) NFPA 70.
In Canada, refer to the current editions of the National Standards
of Canada CAN/CGA-B149.1 and .2 Natural Gas and Propane
Installation Codes, and Canadian Electrical Code CSA C22.1
Recognize safety information. This is the safety-alert symbol AY
When you see this symbol on the unit and in instructions or
manuals, be alert to the potential for personal injury.
Understand the signal words DANGER, WARNING, and
CAUTION. These words are used with the safety-alert symbol.
DANGER identifies the most serious hazards which will result in
severe personal injury or death, WARNING signifies hazards
which could result in personal injury or death, CAUTION is
used to identify unsafe practices which may result in minor
personal injury or product and property damage. NOTE is used
to highlight suggestions which will result in enhanced
installation, reliability, or operation.
FIRE, EXPLOSION, ELECTRICAL SHOCK
HAZARD
Failure to follow this warning could result in personal injury,
death and/or property damage.
Before installing or servicing unit, always turn off main
electrical and gas to unit and tag with appropriate lockout.
There may be more than one disconnect switch.
4& CAUTION
CUT HAZARD
Failure to follow this caution may result in personal injury.
Sheet metal parts may have sharp edges or burrs. Use care
and wear appropriate protective clothing, safety glasses and
gloves when handling parts and servicing furnaces.
4& CAUTION
UNIT DAMAGE HAZARD
Failure to follow this caution may result in improper and
dangerous operation.
Label all wires prior to disconnection when servicing
controls.
Table 1 — Kit Applicability
UNIT
352MAV
KIT PART NUMBER 352AAV S8MEC
58MTA
353BAV CeMre
PGOMXA
326058-755 036060 060-12
036080 080-42
326058-756 048080 080-16
048100 100-16
326058-757 060100 100-20
326058-758 060120 420-20
INTRODUCTION
This instruction covers installation of the permanent split
capacitor (PSC) two-speed motor inducer assembly kit. See
Table 1 for kit applicability.
DESCRIPTION AND USAGE
Use this PSC two-speed inducer assembly kit to replace a failed
inducer motor assembly. This kit contains the following items:
Inducer assembly 1
Installation Instructions 1
NOTE: Inducer assembly consists of motor and fan, capacitor,
wheel, motor mount, inducer cover, inducer housing, vent cap,
and vent clamp.