Getting Started - Adaptive Micro Systems SOUND+SLEEP Aquarius Owner's Manual

Getting Started

Unpack
the box, which contains:
1.
Aquarius Unit
2.
AC Power Adapter & Power Cable
3.
Remote Control
4.
User Manual (this document)
Connect Power
into the USB-C connector on the lower right edge of Aquarius (see above), then
plug the larger USB-A end of the Power Cable into the supplied AC Power Adapter.
Plug the Power Adapter into an un-switched wall outlet. The Aquarius USB-C
connector only provides power to the Aquarius unit.
Note: Aquarius can also be powered by the internal battery when AC power is not
available. If you prefer, you can leave your Aquarius plugged in all the time. When
the internal battery is charging the red charging light will be on.
Turn on Aquarius
immediately with the Power Button, or turned off gradually over time with the Sleep
Timer (see page 6).
Note: The unit starts in the ocean category with richness level 1 in that category
selected. After that the unit will return to the settings used when you last powered
it off using the power button or turned off using the Sleep Timer.
Press The Center Button
Richness Button to select the complexity of the sound (see page 5). Adjust the
volume with the Volume Up/Down Buttons to a comfortable level. If you try to
increase volume beyond the maximum level the Timer light will flash.
Power Button
On/Off
Richness
Button
(3 levels)
Category
Lights
(6x: ocean, ...)
Microphone
Timer Button
(1, 2 or 3 hours)
by gently pushing the USB-C plug end of the Power Cable
by pressing the Power Button. The unit can be turned off
to select the desired sound category. Press the
Headphone Jack
USB-C Connector
5
Remote Control
IR sensor
Volume Buttons
Up & Down
Charging Light
(Near whales light)
Category Button
Bluetooth Button
(3 modes)
BT-off
BT-in
BT-out